Sunday, February 15, 2009

B-Furnace continued

One picture didn't make the last post - the finished B-Furnace body - you will note that this time I measured and drew lines for the various platforms while the piece was still in the lathe.  This is very simple to do on a spinning object, while for A-Furnace I will have to go back and take a lot of measurements just to get to the same place.  
I also have sprayed both furnaces with a shellac spray to seal the wood and hopefully keep any movement to a minimum down the road.  It also gives me a non-porous surface for glue to adhere better to.

No comments: